The Renold REGV Series Trapped Roller Freewheels are self-centering by means of plain bearings.

Torque is transmitted to the inner race via a key and the outer race via the torque arm. Shaft tolerance must be h6.

The primary use for the REGV freewheels is as a backstop. The freewheel should be fixed to the machine body by placing brackets on either side of the torque arm or by using a pin or bolt in the slot. Note that a clearance of 1% of slot width is needed between torque arm and brackets or slot and pin. If a bolt is used instead of a pin it must not apply any axial loads to the torque arm.

Backstopping

• Inclined Conveyors
• Belt / Bucket Conveyors
• Screw Pumps / Pumps
• Escalators
• Gear Drives
• Ventilators / Fans

An alternative application would be indexing where a push rod is connected to the torque arm slot. Clearance between slot and pin must be 1% of slot width.

The REGV is supplied pre filled with grease and normally requires no further sealing.

Indexing

• Metal Stamping
• Press Working
• Packaging Machines
• Indexing Machines
• Assembly Machines Printing Machines

For use in areas where accuracy and consistency is required.